6
The DC power adapter has a fused DC plug and connecting cord stored inside the DC
power adapter. To use the DC power adapter, first remove the DC plug from it’s
storage in the adapter. Remove the cord from storage, and connect the DC power
adapter to the compressor. Make sure it snaps into position. Connect the DC plug to a
12 volt DC source. To remove the DC power adapter, press the release buttons. Put the
DC plug and cord in the adapter for storage after use.
FIGURE 3
5.
CHARGING/RECHARGING THE BATTERY PACK
Lead acid batteries require periodic charging to maintain a full charge and to ensure
good battery life. All lead acid batteries suffer from self-discharge over time, and more
rapidly when they are at higher temperatures. Therefore, these types of batteries need
periodic charging to replace energy lost through self-discharge. When the battery pack
is not in use, Vector recommends that the battery is recharged at least every 60 days.
All batteries must be recharged as soon as possible after each use. If a battery is allowed
to remain in a discharged state, battery life will be reduced.
The time required to fully recharge the battery pack depends on the charge status
of the battery after it’s use. If the battery is discharged from recent use, recharge the
battery for 8 hours.
5.1
AC RECHARGE OF BATTERY PACK
AC recharge requires the use of the supplied AC/DC adapter. The AC adapter
must be powered from 110/120 volt AC, 60 Hz North American standard AC recep-
tacles. The battery pack must be removed from the compressor (applicance) body to
gain access to the recharge port.
NOTE:
Recharging battery after each use will prolong battery life; frequent heavy
discharges between recharges will reduce battery life. Overcharging will reduce
battery life. Never charge for more than 24 hours.
5
3. ATTACHING THE COMPRESSOR’S AIR HOSE
The air hose is supplied as a separate item from the compressor body. The hose has
a ribbed brass fitting at one end and a standard tire chuck at the other end. To use the
hose it must first be connected to the compressor outlet. Loosen the hose retaining ring
(counterclockwise), insert the hose fitting into the short, rubber sealing sleeve. Make
sure the hose fitting is inserted fully into the sleeve. Partially tighten (clockwise) the
hose-retaining ring and push the fitting in further. Do this two or three times until the
fitting is firmly attached and the ring is firmly tightened.
4.
POWERING THE COMPRESSOR, INFLATOR OR LAMP
The appliances can be powered either from a supplied battery pack or from a
supplied DC power adapter.
4.1
POWERING FROM THE BATTERY PACK
The supplied battery pack powers the compressor or inflator for a short duration,
cordless operation. The battery pack should be fully charged initially before use (see
paragraph 5 for charging instructions.
To connect the charged battery pack to either the compressor or lamp, align the
battery pack so the battery release buttons snap onto the appropriate appliance. The
battery pack fits only one way to ensure correct polarity of the contacts. To remove the
battery pack, press the battery pack release buttons.
4.2
DC POWER ADAPTER USE
The DC power adapter can power an appliance for a longer period of time from an
external 12 volt DC power source.
WARNINGS:
1. There is risk of dust or dirt being released if the compressor hose or nozzles
are not clean when the compressor is turned on.
2. Wearing protective goggles while operating this compressor can protect
eyes from flying particles of dust and dirt. Failure to follow instructions may
cause property damage, and/or personal injury.
3. Keep out of reach of children.
WARNING:
Improperly attached hoses or nozzles can fly out under compressor pressure.
Make sure the connections are tight.
FUSED DC PLUG
CONTACT
RELEASE BUTTON
