VECTECH 492EP, Руководство по эксплуатации, Страница: 4 / 10

* Note: the foot end test cable connection, please test the connection is correct.If the test cables
plugged into the wrong foot end, output indicator will foot, please exchange connection plug
location at this time.
6.
Fixed columns: after connected at the bottom of the well, remove the package of three 6 x
25 hex socket screws, according to the icon will be fixed on the column base plate, the post
tighten screw
.
7. Fixed column panel: after connected at the top of the line, using column panel comes with
three screws, nuts will be fixed on the upright post panel.Then tester is fixed on the upright
post panel: floor has three holes on the back of tester, pillar panel on the left side of the three
screw, is used to test instrument are attached in the column on the front panel.
8.
Access control cables (gray) and the power supply ground wire (gray & yellow-green) can
choose according to need.When used, the entrance guard cables or power supply ground
wire wear into the column, wear out, from the top post at one end and the tester is connected
to the plug of the relative should be on the back, from the other end of the column at the
bottom of the wear out
.
Page 3