41
GETTING TO KNOW YOUR IVH-9200
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block located in the back panel. It is below the general wiring
configuration.
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note:
1. DC power source and IGN share the same ground.
2. IVH-9200 supports 6V~36V wide range DC power input in ATX/AT mode. In
Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
3. For proper ignition control, the power button setting should be “Power down”
mode.
In Windows, for
example, you need
to set “When I press
the power button” to
"Shut down."
Pin No.
Definition
1
Ignition (IGN)
2
External Power S/W +
3
External Power S/W +
IGN
V+
Содержание IVH-9200
Страница 52: ...45 HARDWARE INSTALLATION Step 6 Remove the rear panel Step 7 Finish Step 5 Remove SATA Power and COM cables...
Страница 54: ...47 HARDWARE INSTALLATION Step 4 Open the CPU socket Be careful CPU pins Step 3 CPU socket...
Страница 62: ...55 HARDWARE INSTALLATION Step 3 Finish Step 4 Install SSD HDD...