Vecow ARS-2000, Руководство пользователя

Страница: 59 / 114

52
GETTING TO KNOW YOUR ARS-2000 ©Vecow ARS-2000 User Manual
2.7.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block located in the back panel. Please find below the
general wiring configuration.
For testing purpose, you can refer to the picture above to simulate ignition
signal input controlled by a latching switch.
V+ Positive polarity of DC power input (Car for 12/24V)
V- Ground of DC power input (Car battery -/GND line to GND)
IGN Ignition signal input (ACC power of vehicle)
Pin No. Definition
1 Ignition (IGN)
2 External Power S/W +
3 External Power S/W +
IGN
V+
Note:
1. DC power source and IGN share the same ground.
2. ARS-2000 supports 6V to 36V wide range DC power input in ATX/AT
mode. In Ignition mode, the input voltage is fixed to 12V/24V for car battery
scenario.
3. For proper ignition control, the power button setting should be “Power Down”
mode.