11/14
1-9
6
15
16
17
*
13
14
Reconnect the battery after inspecting the connection.
If necessary, replace the main circuit switch. Turn on the igni-
tion and conduct a functional test.
Reprogram other instruments that may have lost their saved
settings.
Place the bracket on the stud bolt and hand-tighten the
knurled nut.
* Make sure the seal lays flat between the panel and the
bezel (see Fig. 13).
•
Please note that when you disconnect the battery all volatile electronic mem-
ories lose their input values and must be reprogrammed.
GB
INSTALLATION INSTRUCTIONS: Viewline 110 mm
TU00-0758-5307102
Technische Änderungen vorbehalten - Technical details subject to change
TU00-0758-5307102
GPS Speedometer
Align the instrument and hand-tighten the fastening nut.
Ensure that the nut is not tightened with a torque greater than
400 Ncm.
* Make sure the seal lays flat between the panel and the
bezel.
If you would like to omit the fastening nut, you may use the
part set A2C59510854 as an alternative.
This is recommended if the installation location is
subject to vibratory loads. Screw the stud bolts into the pro-
vided drill holes in the enclosure. Max. stud bolt torque is 1.5
Nm.