Priority configuration for monitor 1 (front monitor)
For the fully equipped multimedia system (MI 2200 + reversing navigation system
+ 2 external video sources), the following priorities are defined for switching the sources to
monitor 1:
1. Reverse gear engaged –> reversing camera image appears on monitor 1.
2. Reverse gear not engaged –> navigation system image appears on monitor 1.
3. Reverse gear not engaged, parking brake applied –> external video source (if switched on)
can be selected via the “Stand-by” option in the Start menu of the navigation system for
monitor 1.
Monitor 2 (rear monitor) is not intended for the display of rear-view or navigation images.
Consequently, it starts up in standby mode and can be switched to an active AV source using
the remote control.
If monitor 1 is used solely for entertainment purposes, the switching behaviour is the same
as for monitor 2.
Source selection
By pressing the buttons assigned to the relevant monitors (
8
button for monitor 1,
2
button for monitor 2) on the remote control, the MI 2200 toggles through the available
sources as follows:
AV 1 –> AV2 –> Stand-by –> AV1 ...
✎
Any remote control command recognised by the MI 2200 is confirmed by a short audible
signal.
Note:
If a PC 5400 or PC 5500 navigation computer is installed, the selectable sources
additionally include the navigation image (CVBS signal with slightly lower quality than
original RGB).
Volume control
☞
Press the button assigned to the relevant monitor (
8
button for monitor 1,
2
button for monitor 2) on the remote control for more than 1 second.
✎
A long audible signal indicates that you can adjust the volume.
☞
Press
8
button to increase the volume level step-by-step.
☞
Press
2
button to decrease the volume level step-by-step.
☞
To end the volume adjustment, press the button assigned to the relevant monitor once
again for more than 1 second until an audible signal sounds,
or:
☞
simply wait for 5 seconds without operating the system.
■
Audio output
The MI 2200 provides direct sound to both monitors. It additionally offers a Stereo RCA
(Cinch) output for monitor 1 for connection to an optional car stereo or amplifier.
To enable sound via headphone(s) an optional RST 5400 must be connected. This easily
integrated Rear Seat Terminal allows the connection of headphones (min. 32 Ohm) for both
monitors and also offers also RCA connections for AV2 input (i.e. for a mobile video source
such as a camcorder).
Note:
When the RST 5400 is used with headphones, it is recommended to set the volume of
the monitors to 0 (Mute).
OPERATING INSTRUCTIONS
6
Содержание MI 2200
Страница 2: ...2 ...
Страница 11: ...09 2003 ri MI 2200 Car Multimedia Systems VDO Dayton The Car Brand ...