MC 2.0 WR
VDO CYCLECOMPUTING
144
DE
ENG
FR
ES
IT
NL
PL
5 Instalación
5.1 Montaje del sensor, imán y soporte para manillar
>>> P01
Comience con el montaje del sensor y del imán.
paso 1
Colocar el sensor en la suspensión delantera con la ayuda
de la bridas y dejándolo flojo por si hay que hacer ajustes finales.
Es posible el montaje tanto en el lado derecho de la suspensión
como en el izquierdo.
ATENCIÓN: La marca del sensor en el
sensor
debe indicar hacia
los radios.
El transmisor puede montarse, según las condiciones
existentes de lugar libre, adelante sobre la horquilla, internamente en
la horquilla o por detrás de la horquilla.
>>> P02
paso 2
Colocar el imán en el radio dejándolo flojo por si hay que hacer
ajustes finales. El imán debe apuntar hacia el marcaje del sensor en
el sensor.
paso 3
Lleva a cabo los ajustes finales de posición del imán hacia el
marcaje del Sensor, asegurándote que la distancia entre el imán y
el marcaje del sensor es de 1 a 5 mm. Para conseguir esa distancia
también debes ajustar la posición del Sensor con respecto al imán.
paso 4
Para fijar finalmente el Transmisor, ajusta fuertemente las
bridas. Corta el sobrante.
paso 5
Para fijar finalmente el imán, presiona el protector del imán
hasta que esté fijado al radio de forma segura.
paso 6
Mantén el cable ordenado y enrollado alrededor de la horquilla
y a lo largo del cale de freno hacia el manillar.
ATENCION: Durante el montaje mueve el manillar y comprueba el
recorrido de la suspensión (en el caso de horquilla de suspensión) para
asegurarte de que el cable no esté demasiado tirante y pueda rajarse
durante el pedaleo.
Содержание MC 2.0 WR
Страница 226: ...MC 2 0 WR VDO CYCLECOMPUTING 226...
Страница 227: ...www vdocyclecomputing com MC 2 0 WR 227...
Страница 228: ...MC 2 0 www cyclecomputing com CP82000...