IT
NL
PL
FR
ES
ENG
DE
www.vdocyclecomputing.com
MC 2.0 WL 95
Si vous êtes absolument sûr de vouloir rétablir les réglages d'usine de
la MC 2.0, confirmez avec
M
.
MISE A ZErO--rEGLAGE OK apparait pour indiquer la confirmation.
4.4 Rétablissement des réglages d'usine
Les réglages d'usine du MC 2.0 peuvent être rétablis.
ATTENTION : Toutes les données, ainsi que les réglages personnels
sont alors effacés.
B
Maintenez toutes les touches enfoncées pendant 3 secondes.
B
La requête rEGL. USInE--MISE A ZErO? apparaît à l'écran.
5 Installation
5.1 Montage de l’émetteur, de l’aimant et du support pour guidon
>>> P01
Commencez par le montage de l’émetteur et de l’aimant.
ATTENTION : L’écart entre l’émetteur et le compteur placé sur le
guidon ne doit pas dépassé 70 cm (portée des ondes).
etape 1
Placez la rondelle en caoutchouc sous l'émetteur. Montez
l’émetteur sur la fourche, du côté où vous souhaitez monter le
compteur (à droite ou à gauche), au moyen d’un serre-câble
(sans la serrer dans un premier temps).
ATTEnTIOn : La marque du capteur sur l’émetteur doit être orientée
vers les rayons. En fonction de l’espace disponible, l’émetteur peut
être monté à l’avant de la fourche, au centre ou tourné vers l'arrière,
sur la fourche.
>>> P03
etape 2
Placez l'aimant sur un rayon extérieur. Le cœur argenté de
l'aimant doit être tourné vers l'émetteur. Alignez l'aimant et la marque
du capteur sur l'émetteur, avec un écart d'env. 1 à 5 mm.
etape 3
Alignez et fixez définitivement l'émetteur et l'aimant : serrez le
serre-câbles et enfoncez vigoureusement l'aimant.
etape 4
Décidez du lieu de montage : guidon ou cadre. Tournez le pied
du support pour guidon à 90° en conséquence. A cette fin, desserrez les
vis du support, retirez le pied et le tourner à 90°, remettez-le en place
et resserrez les vis.
ATTENTION : Ne serrez pas les vis trop fermement.