Installing the Roller Interface Module
Connection J13 – Trailing cable interface (optional)
16
• Edition 01/2
009
Connection J13 – Trailing cable interface (optional)
Communication between the CTC II and the Roller Interface Module normally
takes place via Bluetooth (wireless).
If wireless communication is not possible due to strong interference at the test
stand, a trailing cable can be used to change to serial connection; also see the
Chapter entitled “Configuring communication via a trailing cable”
on
Page 31
◄
Important
To install the trailing cable connection (serial connection cable), a press cut
must be broken out of the Roller Interface Module's housing. If the press cut
is broken out unnecessarily, the protection class of the Roller Interface Module
will be affected.
Check whether or not the Bluetooth module has to be replaced basing the
check on the operating status of the Roller Interface Module as well as the field
strength displayed at the CTC II; see the
Chapters entitled “Operating status
of the Roller Interface Module”
on
Page 10
and
on
Page 29
◄
Important
You have a Bluetooth Replacement Set available.
The Bluetooth Replacement Set consists of
•
a connection cable with an 8-pin plug connection and an interface for the
trailing cable with a union nut, and
•
20 m of trailing cable.
◄
Condition