7
* Depending on version
AUDIO
ON/OFF
• Press
to switch on the set. Press
for
more than 2 seconds to switch off the set.
VOLUME
• Press the volume button up/down to adjust the
volume.
Please make sure you can still hear the traffic
(horns, sirens........)
MUTE (Silence)
Short press
key to mute or cancel the mute
(silence).
Note : The silence period may be interrupted by
ALARM announcement or traffic announcement
messages (if TA is switched on).
SOUND
Whether you listen to Jazz, Vocal, Pop, Classic or
Rock music, the SOUND button is the perfect
setting for your choice.
• Press SOUND then the sound button to select
BASS-Treb for your own sound style, or adjust
the settings with the volume up/down buttons
to select one of the pre define sound styles:
- BASS-TRE :
Your own settings of bass
and treble.
- FLAT:
Original
- JAZZ:
Jazz music
- VOCAL :
Speech
- POP :
Pop music
- CLASSIC :
Classical music
- ROCK :
Rock music
AUDIO SETTING
• Press SOUND to select desired audio mode.
• Adjust the settings with the volume up/down
buttons:
- Sound style
(BASS-TRE,FLAT,JAZZ,
VOCAL, POP, CLASSIC,
ROCK)
- BASS
(low notes)
- TREBLE
(high notes)
- BALANCE
(left-right)
- FADER
(rear-front)
- LOUD
(OFF, LOW, MID, HIGH)
• Press the volume button to adjust the selected
audio mode.
After 5 seconds the display goes back to the
last mode of operation.
Adjustment of Bass and Treble setting is only
possible when BASS-TRE is selected as the
sound style.
2 Enter the code as described in "Entering the
code". You will hear two beeps indicating that
the Code Protection has been deactivated.
If an incorrect code is entered, you have to follow
the same procedure as described in "Entering
the code".
Activating the Code Protection
•
While keeping the
key pressed, switch on
the set. Keep the
pressed until the display
shows "CODE" and you hear a beep. The
Code Protection is now active.
IF THE SET HAS TO BE SENT FOR REPAIR
•
Deactivate the Code Protection(as described
above), or
Write the protection code on a label and at-
tach it to the set. After repair, remove the label
from the set.
Note:
Code Protection function is deactivated ex-works.
IDENTIFICATION NUMBER
This set has an identification number (stated on
the 'Security card'). Show this card as a proof of
ownership, when the set is stolen or when
requesting service.
• Do not keep the 'Security Card' in your car.
ｄｃｒｅｎｇｌｉｓｈ．ｐ６５
2004-4-30, 14:38
7
