2.5.3.5Service Message
The Service Message indication is based on operating hours and odome-
ter.
The Graphic Symbol Area displays the "Service Symbol" in case a Service
Message becomes due.
The corresponding service code is shown on the centre line of the display
centre. As a "unit" the word "CODE" appears to indicate, that the value is a
code number.
To see the different active Service Messages in the Service Message di-
splay group the button has to be pressed longer than 50 msec.
2.5.3.6Physical Value Display
The graphic display area shows a symbol relating to the physical value di-
splayed. The symbol can be selected via configuration from the defined
symbols in ROM or EEPROM.
In the standard form the physical value is shown on a single Centre-Line,
followed by the physical unit. This unit text can be selected from ROM du-
ring configuration.
If the value is outside of the configurated range, then "------" is
shown.
To see the different Physical Values in the Physical Value display group
the button has to be pressed longer than 50 msec
2. Functional Specification
Product Manual
Service Message
Service
Symbol
Service Code
Configuration Option:
The Service Message indication can be con-
figured as stand- alone or interval message.
Physical Value Display
ISO
Symbol
Physical value
6 Digit Value
Physical Value Display
ISO
Symbol
6 Digit
Label
6 Digit Value
Configuration Option:
As an option a text label can provide identifi-
cation for the value displayed. For example
Battery one of two batteries, or Motor-2 of
two motors. The text label can be configured
via WINgauge with maximum 6 letters.
The physical value is displayed in the lower
centre line.
Physical
Unit
Technische Änderungen vorbehalten Technical details subject to change
2 - 16
TU00-0726-0000002
0609
Содержание CANcockpit Series
