21
M6
Function testing
Once the transmitter is attached, check that it functions
correctly.
How to test the transmitter:
– Insert the computer into the bracket.
The speed indicator flashes. The computer now searches
for its speed transmitter.
– Lift and spin the front wheel.
The green LED on the transmitter flashes several times.
– A speed should now be displayed on the computer.
If the cadence option is activated, the
cadence transmitter must also be paired:
– The cadence indicator flashes. The computer now
searches for its cadence transmitter.
– Rotate the crank or set off.
The green LED on the cadence transmitter flashes
several times.
– A speed should now be displayed on the computer.
If the heart rate option is activated, the heart rate
transmitter must also be paired:
– The heart rate indicator flashes. The computer now
searches for its heart rate transmitter.
– Put on the heart rate transmitter and wait a few seconds.
– A heart rate should now be displayed on the computer.
If no speed, cadence or heart rate is displayed,
there can be several reasons for this.
The possible reasons are described in the
“Troubleshooting”
section.
Pairing the transmitter (initial use)
The VDO M6 automatically pairs the transmitter.
Once the computer has been rotated into place in the bracket,
it starts searching for the transmitter.
The transmitter search is identified by the flashing digits for:
– Speed
– Heart rate (if the heart rate option is activated)
– Cadence (if the cadence option is activated)
The VDO M6 has an automatic bike recognition function.
Depending on whether you are using bike 1 or bike 2,
the data is recorded for bike 1 or bike 2.
ATTENTION:
When other radio signals interfere during the
pairing function, the display shows the message
“Too Many
Signals”
.
Confirm this message by pressing any key. You will then need
to leave this location and move to another location. Untwist
the computer from the handlbar bracket. Then reinsert the
computer into the handlebar bracket. The computer will now
attempt another pairing.
Potential source of interference:
– LED lights
– Mobile telephone
– GPS recever
– WLAN
– Anti-theft security systems inside the store
These sources can interfere with the pairing.
ATTENTION:
when using the transmitter for the first time, the
bike recognition switch must be set to either BIKE 1 or BIKE 2.
Only then will the automatic bike recognition work.
Press and
HOLD
the button until the LED flashes.
Green flashes once = bike 1 is selected
Red flashes twice = bike 2 is selected