VCM Lite, Руководство пользователя, Страница: 5 / 7

Concern VCM Lite LED is not illuminated Correction > Verify that vehicle power is present
on terminals 4,5 and 16 at the DLC
connector. To further confirm DLC
connector integrity verify that another
scan tool is able to be powered from
the vehicle DLC connector. Note: .The
LED will flash green initially then
alternating green and blue to indicate
that Bluetooth pairing has occurred
successfully.
Concern All XXXXXs are displayed when
attempting to read the VIN on the home
screen.
Correction Ensure that the LED is flashing on the
VCM Lite (green) and the vehicle
ignition is on. After verifying that the
vehicle ignition is on closely inspect
DLC terminals 6 and 14 and 3 and 11
for signs of lose pin fit and correct any
concerns observed.
Concern VCM Lite LED flashes alternating green
and red for 1 minute when the VCM Lite
is connected to the DLC connector.
Additional information: This LED
sequence indicates that a fault is
present, yet VCM Lite operation will not
be inhibited after the sequence has
stopped.
Correction >Remove the SD card and attempt to
identify the vehicle and start a Ford
DiagNow vehicle session. If the LED
no longer flashes alternating green
and red this confirms that the SD card
has a fault and should be replaced. (if
used)
Concern VCM Lite LED flashes alternating green
and red for approximately 2 minutes.
Correction >This is an indication that the VCM
Lite is in the process of formatting the
SD card. The SD card will be ready
for use after formatting has been
completed.
Note : A firmware update of the VCM Lite software can be prompted be depressing and holding the push button at the
back of the VCM Lite (molded into hinge portion of the compartment cover, cover does not need to be removed) before
the VCM Lite is connected to the DLC connector followed by releasing the button 5 seconds after the VCM Lite powers
up. The LEDs will then flash at an increased rate which indicates that the firmware will then be updated when a
Bluetooth connection is made with the mobile device.
Troubleshooting: VCM Lite – Vehicle Interface
Warranty Terms and Conditions
During the Two-Year Warranty period, MAHLE Aftermarket Inc., Service Solutions (MSS) is solely responsible for costs
associated with parts and labor for repairs needed due to defects in material and/or workmanship. MSS is not responsible
for the costs associated with repairs needed due to improper use or a lack of required maintenance. MSS’s goal is to
provide a timely turn-around of the covered product requiring warranty repair.
The customer is responsible to ASSIST AND PARTICIPATE with Ford Technical Support in the over-the-phone, web contact
and or remote diagnosis process of:
• Determining that a legitimate failure has occurred and that the complaint is not the result of inadequate training and
or improper use that can be easily remedied by Ford Technical Support instructions.
• Determining the nature of the failure and that it is reasonable for Ford Technical Support to judge that the failure is
warrantable.