Step 1.
Determine if you will be securing VersaClimber into
a concrete wall or a standard drywall wall with wood
studs.
NOTE:
The wall mounting hardware
provided is for general installation into Concrete
or Drywall with wood studs. Depending on the
wall type or floor, additional hardware may be
required. If this is the case, seek proper hard-
ware and installation recommendation.
Step 2.
If securing to a cement wall, go to Step #8.
For securing to drywall with wood studs continue to
next step #3.
Step 3.
A 2”x6” wood board is recommended. Make the
length of 2”x6” board long enough to span across at
least two vertical wall studs.
NOTE: The number of attached VersaClimber’s
determines the length of the 2”x6” board. For
example, two VersaClimbers mounted requires a
minimum board length of 6’ long, that is properly
secured to the wall.
2”x6” wood board
Wall studs
Cover at least (2)
wall studs
Step 4.
Attach wall mount bracket to the VersaClimber, using (2) bolts.
75”
(190.5 cm)
38”
96.5 cm
From wall to the front 2 bolt holes
on the base of VersaClimber post.
From centerline of wall
bracket to the floor.
To mount the bracket take one of the screws and run it through
the bracket and post and apply locknut. Next, apply the other bolt
and nut, securing 2 bolts and nuts with 9/16” wrenches.
Slide post under the wall mount bracket. With screw and
washer run through the post into the wall mount bracket and
apply the washer and locknut, leave loose and apply the other
3 bolts/nuts. Then tighten.
NOTE:
BEFORE MOUNTING TO WALL,
MAKE SURE BRACKET SLOTS ARE
CENTERED ON WALL BRACKET.
These slots allow movement forward
and backward if adjustments are
needed from the wall.
WALL MOUNTING INSTRUCTIONS
Page 2
