VAXIS STORM 500+, Инструкция по эксплуатации

Страница: 14 / 20

12
4. Operation instruction
■ Getting started
After finishing all steps above, system is workable, follow below steps.
a) Ensure the video source output of the camera is OK, and the HD
monitor is power on and switched to connected video input port.
b) Ensure all input, output SDI or HDMI cables are connected.
c) Ensure both the transmitter and receiver installed batteries or DC
input ports connected to outside power sources. Then toggle
power switch of transmitter and receiver to ‘ON’ respectively,
then ‘Power’ screen will be light.
d) Ensure the transmitter and receiver in same channel(the OLED
screen display the same channel number), and this will make sure
the transmitter and receiver work with same RF frequency.
e) If the camera is on and video input is OK, TX side ‘video’ screen
will be light.
f) Before RX finished wireless link with TX, the Receiver’s wireless
signal strength “RSSI” and the screen “Video” indicator lights are
not light; when wireless link is OK, the Receiver’s wireless signal
strength “RSSI” indicator light will bright, and will indicate the
current signal strength. If the receiver detects normal wireless
video signal from established wireless communication, then the