Cabinet
1. Do not attempt to install fixture while plugging in.
Wall
Important to Know
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes, it is recommended that you consult with
a qualified electrician.
3. Maximum number of LED cabinet lighting fixtures per run should not exceed power supply wattage
rating. (Maximum 24W)(Linkable up to 2 fixtures)
4. Do not use in wet locations, use indoors only.
5. Non-replaceable LEDs.
6. LED light output is strong enough to injure human eyes. Precautions must be taken to prevent
looking directly at the LEDs with unaided eyes.
7.
Specification:
Important safety instructions.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
X0090
Installation Steps
Fig.1.
Counter Top
NO.
1
Dimension(inch)
Item #.
X0090
24
3
A
B
C
0.625
Maximum
Watts
12
A
B
C
Hardware Package:
(1 SET)
Page 1
1. Find a suitable location to mount the fixture, make sure
that the 24W driver (with 5 ft. power cord) will reach the
nearest electrical outlet. The mounting surface should
be a minimum of 1/2” thick (Fig.1).
Note: The recommended mounting for the cabinet light
fixture is near the front lip of your under cabinets as
shown in the figure 1. This provides the best light
distribution across a countertop.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
161125
Fig.2.
Mounting Bracket
Key hole
2.Use your fingernails or a small, flat-head screwdriver,
gently pry the mounting bracket until it
opens. (See Fig 2.)
