Page 3 / 5
Fig. 4
Fig.5
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side
of the bottom surface of the sensor. (See Fig. 4)
● Adjust motion sensor sensitivity to achieve desired performance.
● Approximate range for each setting from 10ft to 85ft.
Adjusting the Light Head:
1. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the light
heads at least 1” (25mm) away from the sensor.(See Fig. 5)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and electrical shock.
Light Head
Sensitivity of Motion Sensor
221021
Functions and Operations
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.4)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. TEST MODE (daytime and nighttime operation.)
● Rotate Time knob arrow on the left side of the sensor head to the "TEST" position.
● The light turns to high-level brightness (5000K) when motion is detected, and stays on as long as the motion
continues. Then it reverts back to pre-selected low-level brightness (0% ~ 50%) and CCT color (2700K ~ 5000K)
about 5 seconds after motion is no longer detected.
2. OFF MODE (nighttime operation only)
● In "OFF" mode, slide the Time Delay knob to the desired time(30s/1min/3min). At dusk, the light stays off,
the light turns to high-level brightness (5000K) when motion is detected, and stays on as long as motion continues.
When the motion is no longer detected, it remains on for the predetermined shut-off delay time you set
(30s/1min/3min), and then turns off automatically.
● The light turns off automatically at dawn.
3. AUTO MODE (nighttime operation only)
● In "AUTO" mode, rotate Time Delay knob to the desired time setting
(30s/1min/3min). At dusk, the light turns on to pre-selected low-level
brightness and CCT color. When motion is detected, the light turns
to full brightness (5000K) and stays on as long as motion continues.
When the motion is no longer detected, the light at full brightness (5000K),
remains on for predetermined time you set (30s/1min/3min), and then
switch back to the set low level brightness and CCT color automatically.
● The light turns off automatically at dawn.
Note: You can adjust the low-level brightness (0~50%) and CCT color (2700K~5000K) by using the
low-level brightness (0~50%) knob and CCT color (2700K~5000K) knob on the backplate (See Fig.6)
4. PC MODE (nighttime operation only)
● In "PC" mode, the light turns on at full brightness at dusk and remains on until dawn.
Note: You can adjust the CCT color (2700K~5000K) by using the CCT color (2700K ~5000K) knob on the
backplate. (See Fig.6)
LUMEN
0%
50%
Fig.6
L H
M
MODE
Off
Auto
PC
3H
Test 3min
1min
30s
Custom Setting
