background image

181205

 

2. Attach the mounting plate (A) to the outlet box by using two mounting screws (B).

3. Make the bottom of the fixture upward, gently place four glass panels into the metal 

    frame, then press the clips to secure the glass panels.(Fig.1)

   

4. Pull out the source wires from the outlet box. Make wire connections using wire 

     connectors (C) as follows:

    ---Connect the hot wire (usually black insulation) from the fixture to the 

        black wire from the power source.

    ---Connect the neutral wire (usually white insulation) from the fixture to the 

        white wire from the power source.

    ---Attach the fixture grounding wire (usually green insulation or bare wire) to  

       the mounting plate (A) with the green grounding screw (E), and then 

       connect it to the house grounding wire with the wire connector (C).  

       Carefully put the wires back into the outlet box.

5. Attach the fixture to the mounting plate (A) by inserting headless screws (D) into holes on back plate, and then secure it 

    with two rubber pads (H) and two ball nuts (G).

 

   NOTE: With silicone caulking compound,caulk complete around the back plate meets with the wall surface to

    prevent water from seeping into the outlet box.

6. Attach the candle tubes onto the sockets. 

7. Install three bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.

Turn on the power at fuse or circuit box.

1. Turn off the power at the fuse or circuit box before starting installation.

2. Loosen the wire connector connected with the wires from photocell. (See Fig.2)

    

Note: Do not move the photocell to prevent water from seeping into the outlet box.

3

Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.3)

    a. The black wire from the fixture to one end of the black pigtail.

    b. The white wire from the fixture to one end of the white pigtail.

    c. The other end of the black pigtail to the black wire from the power source.

    d. The other end of the white pigtail to the white wire from the power source.

    Put all wires back into the back plate of the fixture.

Operation the Unit Without Photocell

 

Photocell

White Wires From Photocell

Wire Connector

Wires From Fixture

White Pigtail

Red Wires From Photocell

Black wires From Photocell

Fig.2

 

Wires From Fixture

Wires From

Main Power 

Wire Connector (C)

Pigtail

Fig.3

Turn on the power at fuse or circuit box.

Glass Panel 

Clip

Metal 

Frame 

Fig.1

Отзывы: