181029
4. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire connectors (C):
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate (A) with the green grounding screw (E).
Then connect it to the house grounding wire with a wire connector (C).
Carefully put the wires back into the outlet box.
5. Attach the back plate to the mounting plate (A) by inserting the headless screws (D), then secure it
with two rubber pads (H) and two ball nuts (G).
CAUTION: With silicone caulking compound, caulk completely around where the back
plate meets with the wall surface to prevent water from seeping into the outlet box.
6. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
Turn on the power at fuse or circuit box
Turn on the power at fuse or circuit box
1. Turn off the power at the main fuse or circuit breaker box before starting installation.
2. Loosen the wire connectors connected with the wires from photocell. (See Fig.2)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connectors (C):
(See Fig.3)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Photocell
White Wires From Photocell
Wire Connector
Wires From Fixture
Wires From Fixture
Wires From
Main Power
Wire Connector (C)
White Pigtail
Pigtail
Red Wires From Photocell
Black Wires From Photocell
Operation the Unit Without Photocell
Fig.2
Fig.3
