
Page 2 / 4
1. Take a side glass panel and gently place the side glass panel into
the metal frame in place, then pressing the clips of the metal frame
to secure the side glass panel. (See Fig. 1)
2. Repeat this process to complete all glass panel installation of side
glass panels and front glass panel.
3. Attach the metal frame back to the main fixture, secure it with two
set screw.
4. Thread two headless screws through the mounting plate, and then
secure them with four lock nuts (two on each side of the mounting
plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up
horizontally to make the fixture level.
5. Attach mounting plate to the outlet box using two mounting screws.
6. Pull out the wires and grounding wire from the outlet box. Make
wire connections using the wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to
the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw, and then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
7. Attach the back plate to the mounting plate by inserting the headless screws, and then secure it with two rubber pads
and two ball nuts.
NOTE: With silicone caulking compound, caulk completely around where the back plate meets with the wall
surface to prevent water from seeping into the outlet box.
8. Open the door of the fixture by pushing up the latch. Install bulbs (not included). See relamping label at socket area or
packaging for maximum allowed wattage. Close the door of the fixture by pulling down the latch.
Installation Steps
Turn off the power at fuse or circuit box.
Main Fixture
Back plate
Ball Nut (H)
Rubber Pad (G)
Side Glass Panel(J)
Metal Frame
Clip
House Grounding Wire
Green Grounding Screw (C)
Wire Nut (E)
Mounting Screw (B)
Headless Screw (D)
Outlet Box
Fixture Wire
Lock Nut (F)
Mounting Plate (A)
Fixture Grounding Wire
Bulb Type A Max.60W
(not included)
Door
Front Glass Panel (I)
Set Screw
Latch
Fig. 1
Clip
Glass Panel
Turn on the power at fuse or circuit box
171022
Clip