Page 3 / 5
160518
Function and Operation
Choose a mode by
sliding the switch on the bottom of the sensor.
(See Fig.6)
Note: When power is first applied, the light will turn on to 100% brightness. The sensor will take 30 seconds
to warm up.
1. Test mode (daytime or nighttime operation )
● Rotate the knob on the left side of the back plate to the “TEST”
position (See Fig.7)
● With the power on, the light turn
s to low-level brightness
automatically.
● The light turns to high-level brightness when motion is detected,
and stays on as long as the motion continues. Then it reverts back
to low-level brightness about 5 seconds after motion is no longer
detected.
Note: You can adjust the low
level brightness
(0~50%)
by using
the
low level brightness knob on the right side of the back plate
.
(See Fig. 7)
2. AUTO MODE (nighttime operation only)
●
To shift to “AUTO” mode, rotate Time Delay knob arrow to point to
the desired time setting (between 5 seconds and 3 minutes). At
dusk, the light turns on to pre-selected low level brightness. When
motion is detected, the light turns to full brightness and stays on as
long as motion continues. When the motion is no longer detected,
the light at full brightness remains on for the predetermined time you
set (5s ~ 3min), and then switches back to low level automatically.
● The light turns off automatically at dawn.
Note: You can adjust the low
level brightness
(0~50%)
by using
the
low level brightness knob
.
(See Fig. 7)
Adjustment Sensor Lower For Short Coverage
Adjustment Sensor Higher For Long Coverage
Fig. 5
1. Gently grasp the light heads and tilt them up or down, left or right to
adjust the light coverage area. Keep the light heads at least 1˝ (25mm)
away from the sensor.(See Fig. 5)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and
electrical shock.
Fig. 3
Fig. 4
Adjusting the Light Head:
Fig. 6
Fig. 7
Mode
Sensitivity
Delay Time
Low Level Brightness
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side
of the bottom surface of the sensor. (See Fig. 6)
● Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to achieve desired performance.
● Approximate range for each setting: 20 ft. (L), 45 ft. (M), 70 ft. (H).
