151020
Headless
Screw (D)
Lock Nut (E)
A
B
C
A
B
C
Mounting Plate (A)
T0199
T0200
Rubber Pad (G)
4. Attach the fixture to the mounting plate by inserting headless screws into holes on back plate, and then secure it
with two rubber pads and two ball nuts.
NOTE:With silicone caulking compound, caulk completely around where the back plate meets with the
wall surface to prevent water from seeping into the outlet box.
5. Install a bulb (bulbs) (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box.
A: 7"
B: 4-7/8"
C: 4"
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5417MM (1 SET)
1. Turn off the power at the fuse or circuit box before starting installation.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.1)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Photocell
White Wires From Photocell
Wire Nuts
Wires From Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From Photocell
Black Wires From Photocell
Operation the Unit Without Photocell
Fig.1
Fig.2
Mounting Screw (B)
Wire Nut (F)
Ball Nut (G)
Green Grounding
Screw (C)
A: 12"
B: 4-7/8"
C: 4"
