140324
1. Turn off the power at the main fuse or circuit breaker box before starting installation.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.2)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
Photocell
White Wires From Photocell
Wire Nuts
Wires From Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From Photocell
Black Wires From Photocell
Operation the Unit Without Photocell
Fig.2
Fig.3
1. Thread two headless screws through the cross bar, then secure them with four lock nuts (two on
each side of the cross bar). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will
be level.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Place the exterior glass shade into the metal frame carefully, and then secure it by pressing the
clips from the top sides. (See Fig.1)
Note: Slide the outer glass shade downward into the notch inside of the metal frame.
4. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black (hot) wire from the fixture to the black (hot) wire from the power source.
---Connect the white (neutral) wire from the fixture to the white (neutral) wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect
it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
5. Attach the back plate to the cross bar by inserting the headless screws, then secure it with rubber
pads and two ball nuts.
Note: With silicone caulking compound, caulk completely around where the back plate
meets with the wall surface to prevent water from seeping into the outlet box.
6. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
7. Attach the interior glass shade to the glass holder and turn it clockwise until it locks in place.
Note: Do not over tighten.
8. Attach the metal frame to the fixture, then secure it with the ball nut assemblies.
9. Turn on the power at the main fuse or circuit breaker box.
