
PAGE: 8 / 11
Note: 1. Remote controller can not be used along with a solid-state speed control at the same time.
2. The temperature and brightness of light can not be set without remote controller.
Fig.19
HI
MED
LIGHT
0N/0FF
DIMMER
FAN OFF
LOW
Install the battery (9V, included) into the transmitter.
* Press "HI" button to turn on the fan at high speed.
* Press "MED" button to turn the fan in medium speed.
* Press "LOW" button to turn the fan in low speed.
* Press "FAN OFF" button to turn off the fan.
* Press "LIGHT ON /OFF" button to turn on or turn off the light.
* Press and hold the "DIMMER" button to
dim or brighten lights to the desired level and
release, and the brightness level will be memorized. Turn on the light again, then fan
light will be restored to the brightness-level at which it was dimmed last time.
* Press "DIMMER" button to change color temperature of fan light, there are a total of 5
levels of color changing from 2700K,3000K,3500K,4000K to 5000K.
Note:
1. This remote controller has a memory function setting. The fan will operate at the same
speed and the fan light will stay at the same brightness-level as the last time the power
supply was turned off.
2. Compatible Wall Switch: Lutron SKU# DVFSQ-LFH-WH.
a. Warning: This wall switch is not capable of changing the temperature and brightness
of the light. Therefore, it’s important to set your preferred color temperature and
brightness before removing the remote-control receiver from the fan.
b. This LED module has a memory function setting. The fan light will stay at the same
brightness and temperature as the last time of remote control setting. To proceed
with installation without remote control, please start from Fig.20.
Transmitter
Wall Bracket
Screw
19
Install the transmitter wall bracket on the wall with two screws
and place transmitter in it carefully.
Fig.22
Fig.20
Fig.21
21
22
220829
Содержание F0095
Страница 4: ...PAGE 4 11 220829 ...
Страница 9: ...PAGE 9 11 Fig 23 Fig 24 Fig 25 220829 ...
Страница 11: ...PAGE 11 11 220829 ...