www.vax.co.uk
8
belt or brushbar
6. Belt or brushbar: removal
and replacement
TOOL REQUIRED:
Phillips screwdriver
WARNING:
to reduce the risk of injury from moving
parts - unplug cleaner before changing belt or brush.
To remove belt
Lay cleaner flat and flip cleaner to expose nozzle base.
Base should lay flat and face up. To remove nozzle guard,
use Phillips screwdriver to remove the three (3) screws.
Arrows show location of screws.
Flip cleaner right side up. Rotate nozzle guard forward
and lift off.
Lift and remove brushbar. Dispose of old belt.
To replace belt or brushbar
Slide belt onto motorshaft.
Place new belt in area of brushbar without bristles.
With new belt in place, pull and slide brushbar into nozzle
making sure that the brushbar end caps are in the correct
orientation (Fig. 6/5 inset). Rotate brushbar manually to
make sure belt is properly aligned.
Fig.6/1
Fig.6/2
Fig.6/3
MOTOR SHAFT
Fig.6/4
Fig.6/5
Fig.6/6
!
