Getting started
Fixing the wall bracket
PLEASE READ ‘LET’S TALK SAFETY’ BEFORE USE
CAUTION:
The battery used in this device may present a risk of fire or chemical burn if mistreated. Do not
disassemble or heat above manufacturer’s maximum temperature limit (60°C/140°F) or incinerate. Use of another
battery may present a risk of fire or explosion. Dispose of used battery promptly. Keep away from children. Do not
disassemble and do not dispose of in a fire. Do not attempt to disassemble the battery or remove any component
projecting from the battery terminals. The battery and charger have no user serviceable parts. Fire or injury may
result. Prior to disposal, protect exposed terminals with heavy insulating tape to prevent shorting. The battery is to
be disposed of safely at your local battery recycling centre.
Do not attempt to recharge non-rechargeable batteries. The battery must be removed from the appliance before it
is scrapped. The appliance must be disconnected from the charger/supply mains before use and when removing
or installing the battery into the machine. In case of battery leakages avoid any contact with the skin. Contact our
Customer Care Line on: AU 1300 361 505 / NZ 0800 800 900.
Charging the vacuum cleaner
To charge the machine,
detach the reach wand
and place the handheld
on its base. You can also
charge the machine
whilst attached to the
wall mount.
Insert the charging lead
into the charging port
located on the base of
the handle.
Plug the charging plug
into a power point.
Getting started
NOTE:
The initial charge is 4 hours, charging will be required before first use. The vacuum can be charged with
the handheld either attached to, or detached from, the reach wand.
Fully assemble
the vacuum.
Use both screws and wall
plugs to secure the wall
bracket to the wall. Place
covers over the screws.
Slot the wall bracket through the groove
and lift upwards into position.
Firmly press the vacuum
handle into the wall
bracket to secure.
Choose a position where
you would like to keep the
vacuum stored, preferably
near a power point. With
the wall bracket attached,
stand the vacuum close
to the wall, in the upright
position with the Powered
Head flat on the floor.
Using a pencil make
a small mark for
each screw.
Holding the wall bracket
firmly in place, carefully
lift and remove the
vacuum away from
the wall bracket.
