4
assembly
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
Tool required:
Phillips screwdriver
1.
Place the base of the cleaner so it is facing away from
you. Position the body so that the lower hose is on your
right hand side. Push the body down into place.
To secure the body in place insert one of the screws
supplied into the back of the cleaner, through the hole
located above the on/off pedal.
Pull back the flap on the clear window. Match the slots on
the hose to the tabs on the hose inlet. Push down firmly
on the cuff and turn anti-clockwise to lock in place
(Fig.3/1).
2.
Align the holes in the tool holder, with the holes on top
of the body. Use two of the screws supplied to secure the
tool holder in place. Do not over tighten.With the hose clip
on the handle facing you place it onto the top of the body
of the cleaner (Fig.3/2).
3.
Push down firmly and line up the screw hole on the rear
of the handle. Use one of the screws supplied to secure
the handle on the body.
Insert the small end of the main hose into the tool holder
on the right hand side (Fig.3/3).
4.
Using the handle attach the main hose into the left
hand side of the cleaner. Press down firmly to secure in
place. The main hose can then be secured in the top and
side of the tool holder.
Push and twist the dirt container lid firmly on top of the
dirt container and place it onto the cleaner. The dirt
container will snap into place in the body of the cleaner.
Attach the tools to the tool holder. The 2 in 1 tool fits over
a post at the back of the vacuum cleaner.
The crevice tool fits into a round slot on the rear right hand
side of the tool holder. The extension wand hose on the
left hand side (Fig.3/4).
!
Phillips screwdriver required
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
vax.co.uk
