Vax VMSM1500, Руководство пользователя

Страница: 5 / 12

---
www.vax.com.au
5
Operation
---
Operation
How to use
4
Vax Careline
0844 412 8455
H90-GA-B User Guide.qxd:User guide 30/10/09 14:16 Page 4
NOTE: In hard water areas, or to prevent calcium and mineral deposits
from accumulating on the heating element and mop head, you may use
distilled or demineralized water in place of tap water.
1. Always make sure the Steam Mop is unplugged.
2. Make sure the microfiber cleaning pad is properly attached to the
mop head. And install following the procedure described in the
(Before Using for the First Time) section of this Instruction Manual.
WARNING: NEVER USE THE STEAM MOP WITHOUT THE
MICROFIBER CLEANING PAD PROPERLY ATTACHED.
1. For best results, thoroughly sweep or vacuum floor(s) prior to cleaning with the Steam Mop.
2. Twist the quick-release upper cord wrap to either side and unwrap the power cord completely.
3. Lengthen the telescoping handle by pushing the lock forward and then pulling the handle out to
extend to the desired length.
4. Plug the unit into a 240V AC electric outlet. The indicator light will illuminate green.
5. Press the steam pump switch to the ON (I) position. After 30 seconds, an audible hissing noise
can be heard as the unit heats and steam production begins. Steam will wet microfiber
cleaning pad.
6. Tilt the ergonomic handle to a 45-degree angle and clean the floor area slowly. For best
results: The cleaning pad should be changed when it gets too wet or if it is noticeably dirty.
How to use on floors
Water Tank Cap
(roped)
IMPORTANT: Never use the Steam Mop without the microfiber cleaning
pad properly attached to the mop head.
IMPORTANT: Check the water tank viewing window to ensure there is
adequate water in the water tank.
3. Turn the water tank cap counter-clockwise to open. Lift roped cap up and off the tank.
4. Using the water fill cup and funnel, pour one full cup into the water tank.
CAUTION: Check the water tank viewing window to make sure water level does not exceed
the MAX fill line. DO NOT OVERFILL.
5. Replace the water tank cap. Turn clockwise to tighten until snug.