5
Vax Careline
0870 606 1248
operation
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1.
Insert the flexible hose into the inlet on the main body
of the vacuum cleaner. Push in until it clicks into
position (Fig.3/1).
2.
Push the telescopic extension tube on to the end of
the handle (Fig.3/2).
3.
The telescopic extension tube can be lengthened or
shortened by pushing the button in and sliding the
tube apart or together as required (Fig.3/3).
4.
Fit the combination floor head by pushing onto the
extension tube (Fig.3/4).
4. How to Operate
Cord Release
Fully unwind the power cord. A yellow mark on the power
cord indicates the recommended cord length. Do not
exceed the cord length beyond the red mark.
On/Off Button
Insert the power plug into the electrical outlet. Ensure the
vacuum cleaner is switched off.
Press the on/off button located on the top of the vacuum
cleaner and press the button again to turn the vacuum
cleaner off.
Carpet Cleaning
For carpet and rug cleaning press the rocker switch on the
combination floor head to raise the brushes.
(Model:
V-091TB,
V-091X,
V-091P,
V-091PB,
V-091PBA only):
Attach the TurboBrush floor head to the
end of the extension tube. For large carpeted areas only.
(NOTE: not recommended for hard floors)
Hard floor cleaning
For hard floor cleaning, press the rocker switch on the
combination floor head to lower the brushes.
(Model: V-091P, V-091PB, V-091PBA, V-091S only):
Attach the hard floor tool head to the end of the extension
tube. For parquet and laminate coverings.
Cord Rewind
To rewind the power cord, press the cord rewind button,
located on the top of the vacuum cleaner, and guide the
power cord with one hand. This will prevent the cord from
whipping which could cause damage or injury.
Variable Power
Located between the cord rewind button and the on/off
button there is a variable power dial. Rotate this clockwise
and anti-clockwise to adjust the suction power, LEDs will
light up dependant on power level.
Carry Handle
Use the carry handle located behind the cord rewind
button and on/off button to move the vacuum cleaner
from room to room.
Hose Storage
For convenience there is a slot located on either side of
the vacuum cleaner where the floor tool and hose can be
parked for carrying and storage.
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
!
