Belt or Brush Removal and Replacement/Light Bulb Replacement/
TurboTool: Clearing Blockages
7
6. Belt or Brush Removal and
Replacement
1. Lay vacuum cleaner flat and turn over to
expose nozzle base. Base should lay flat and face
up. To remove nozzle guard, use Phillips
screwdriver to remove the three screws. Arrows
show location of screws. Rotate/pivot the nozzle
guard and pull off. Lift and remove brushbar.
Dispose of old belt (Fig 6/1).
2. To replace belt or brushbar, slide belt onto
motorshaft. Place new belt in area of brushbar
without bristles (Fig 6/2).
3. With new belt in place, pull and slide brushbar
into nozzle making sure that the brushbar caps
are in the correct orientation (Fig 6/3a). Rotate
brushbar manually to make sure belt is properly
aligned. Secure by aligning the four tabs in the
base slots. To re-attach nozzle guard, rotate/pivot
back into position. Replace all three screws to
secure nozzle guard.
8. TurboTool: Clearing Blockages
Rotate locking ring 180˚ and turn TurboTool over.
Pivot lower housing and remove clog. To
reassemble, be sure tabs are engaged. Pivot the
lower housing closed. (Fig 8/1).
Fig.6/1
Fig.6/2
Fig.6/3
Fig.6/3a
Slide belt onto motorshaft.
TABS
Fig.8/1
V-040_Ultrixx.qxd 11/4/06 13:22 Page 8
