vax.co.uk
8
belt or brush bar
6. Belt or brushbar: removal
and replacement
TOOL REQUIRED:
Phillips screwdriver
WARNING: to reduce the risk of injury from
moving parts - unplug cleaner before changing
belt or brush.
To remove belt
Lay cleaner flat and flip cleaner to expose nozzle base
(Fig.6/1).
Base should lay flat and face up. To remove nozzle guard,
use Phillips screwdriver to remove the SIX (6) screws.
Arrows show location of screws (Fig.6/1)
Remove sole plate by lifting off (Fig.6/2).
Lift and remove brushbar. Dispose of old belt (Fig.6/3).
To replace belt or brushbar
Slide belt onto motor shaft (Fig.6/4).
Place new belt in area of brushbar without bristles (Fig.6/5).
With new belt in place, pull and slide brushbar into nozzle
making sure that the brushbar end caps are in the correct
orientation (Fig. 6/6 inset). Rotate brushbar manually to
make sure belt is properly aligned.
Fig.6/1
Fig.6/3
Fig.6/4
Fig.6/5
!
Fig.6/6
Fig.6/2
