7
belt & brush replacement / clearing blockages
8. Clearing Blockages
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing
.
Clearing Blockages from the TurboTool
1. Turn the TurboTool over and slide off the O-ring
(Fig.8/1).
2. Pivot lowering housing and remove clog (Fig.8/2).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the O-ring into the groove at
the neck of the TurboTool to complete reassumbly
(Fig.8/3).
9. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: Vacuum cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution:
Plug in firmly.
Cause:
Blown fuse/tripped breaker.
Solution:
Reset circuit breaker or replace fuse.
Cause:
Thermal cut out.
Solution:
Refer to page 3 for information.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Lower hose not connected properly.
Solution:
Refer to page 4 for fitting information.
Cause:
Dirt container not installed correctly, or full.
Solution:
Review dirt container replacement.
Cause:
Broken or worn belt.
Solution:
Replace the belt.
Cause:
Clogged filters.
Solution:
Remove, clean and replace filters.
Cause:
Nozzle/hose or hose inlet is clogged.
Solution:
Remove nozzle/hose and obstruction.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause:
Dirt container full.
Solution:
Empty dirt container.
Cause:
Dirt container not installed correctly.
Solution:
Review dirt container replacement.
Cause:
Hose not installed properly.
Solution:
Review vacuum cleaner assembly.
!
Fig.8/1
Fig.8/2
TABS
Fig.8/3
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
!