5
8.
Before cleaning, determine where to start and
end, making sure not to walk over previously
cleaned areas.
CHECK FOR COLOUR FASTNESS:
Before cleaning carpet, test for colour fastness.
Dampen a white cloth with solution. Test on an
inconspicuous area. Gently rub the cloth over the area.
Check each colour for colour bleeding. If the cloth
remains clean, it should be safe to clean the carpet.
AFTER CLEANING:
• Allow carpet to dry completely. Try not to walk on
the carpet until it is dry.
• If it is necessary to walk on the carpet, place white
towels on the areas to be walked on.
• If the carpet is not dry and the furniture must be
placed back in the room, use plastic or foil under
the furniture to prevent staining the carpet.
• Thoroughly clean the dirty water tank with warm
(max 40
o
C) tap water.
5. How to Operate
Cord Release
IMPORTANT
: Turn off when emptying and filling the
clean and dirty water tanks.
IMPORTANT
: Vacuum carpets thoroughly with a dry
vacuum cleaner before washing.
1. Press the clean water tank release latch and tilt
away from the machine (Fig.5/1).
2. Unscrew the measuring cap from the back of the
clean water tank (Fig.5/2).
Fig.5/1
Fig.5/2
Preparing the Carpet/How to Operate
3. Fill the measuring cap 3
1
/
2
times with Vax AAA
Carpet Cleaner and pour into the clean water tank
(Fig.5/3).
4. Fill the remaining space with lukewarm (max 40ºC)
tap water and replace the measuring cap (Fig.5/4).
NOTE
: Only use Vax AAA Carpet Cleaner, using other
cleaning solutions may cause excessive foaming. This
may cause the float to shut off the carpet washer
prematurely. Using other cleaning solutions with
invalidate your warranty.
5. Place the bottom of the clean water tank into the
carpet washer and position until it clicks into place
(Fig.5/5).
6. Step on the handle release pedal to put the carpet
washer into a reclined position (Fig.5/6).
Fig.5/6
Fig.5/5
Fig.5/3
Fig.5/4
Vax V-022(Q).qxd 23/8/06 11:47 Page 5
