vax.co.uk
6
dirt container & filter / belt & brush replacement
6. Dirt Container & Filter:
Removal and Replacement
1.
Make sure the vacuum cleaner has been switched off
and unplugged from the electrical supply. To remove the
dirt container from the vacuum cleaner press the release
catch and pull forward.
To remove the lid, turn anti-clockwise and lift lid away.
Empty the dirt container (Fig.6/1).
2.
The filter inside the dirt container should be replaced
every 12 months. It should be cleaned each time the dirt
container is emptied.
To remove, twist and pull the filter out. To clean, tap
gently against the side of a dustbin. Do not use a brush to
clean as this may damage the filter.
Replace filter. Push firmly into place to prevent dust and
dirt leaking out. Replace the lid and re-attach dirt container
(Fig.6/2).
7. Belt and Brush:
Removal and Replacement
1.
Unplug the vacuum cleaner from the electrical supply.
Press the recline pedal and turn the vacuum cleaner over
so that the base lies flat and face up. Use a screwdriver to
remove the three screws shown below. Remove the nozzle
guard. (Fig.7/1).
Lift and remove the brushbar (Fig. 7/2), then slide the belt
off the motor shaft and dispose of it. Place new belt on
the motor shaft and then slip the brushbar through the
belt (Fig.7/2a).
The belt should sit on the section of the brushbar without
bristles. Re-fit the brushbar. Ensure the end caps are in the
correct position. Rotate the brushbar to check the belt is
not twisted. Replace the nozzle guard.
Fig.7/1
Fig.6/1
Fig.6/2
Fig.7/2
Fig.7/2a
Vax U90-P4 Series User Guide v1.4.qxd:UG 5/7/11 11:48 Page 6
