5
operation
4. How to Operate
Turn the vacuum cleaner on by pressing the on/off switch
located on the lower right side of the cleaner (Fig.4/1).
The cleaner can be turned off by pressing the on/off
switch again.
Adjusting the Angle of the Main Body
To adjust the angle of the vacuum cleaner body, push the
release pedal on the lower left side of the cleaner (Fig.4/2).
Move the handle to the desired position. (A) for
upright position, (B) for normal operation and (C) to clean
under furniture (Fig.4/2).
Carpet Height Adjuster
The front of the vacuum cleaner has a carpet height
adjuster that raises and lowers the brushbar to suit the
type of carpet. With the cleaner NOT connected to the
electrical outlet, and when the vacuum is in the upright
position set the adjustment to the lowest setting for
maximum cleaning. If the cleaner is difficult to move, push
the knob to the next highest setting until the vacuum is
comfortable to push. The brushbar must reach the carpet
for effective cleaning.(Fig.4/3).
IMPORTANT
: When the vacuum cleaner is stood in
the upright position or when using the hose and
tools, the carpet height adjuster must be set to the
highest position.
WARNING:
To avoid injury, keep loose clothing, hair,
fingers and all other parts of the body away from
any moving part (such as the brushbar). Turn off the
switch and unplug the cleaner before adjusting the
cleaner for the carpet height.
On/ off
switch
Fig.4/1
Fig.4/2
Fig.4/3
!
!
A
B
C
WARNING:
This cleaner has a constantly
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE:
Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.
!
press
here
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
Vax U90-P2 Series User Guide v3.qxd:U90-P2 User Guide 26/2/10 14:58 Page 5
