
9
Vax Careline
0870 606 1248
operation
Position bottom of tank into unit and press on tank handle
to snap tank into place (Fig4/14).
Dirty water tank (lower tank)
The dirty water tank holds the dirty solution that is picked
up from the carpet. When the dirty water tank is full, the
automatic shut-off will engage (see page 7) and the tank
must be emptied.
How to empty
IMPORTANT:
Turn
carpet
cleaner
off
and
disconnect from electrical outlet.
To prevent possible leaking, remove clean solution tank
(Fig.4/8) by pressing down on tank handle and pulling
forward; set tank aside
NOTE:
Do not set tank on furniture
Step on handle release pedal and lower handle until it rests
on the floor. If cleaning stairs or upholstery, remove hose
by reversing procedure as shown on pages 11 and 12.
Rotate rdirty water tank latches outward (one on each side
of tank). Lift tank off of carpet cleaner and carry it to a sink
or drain (Fig4/15).
Unlatch back part of tank lid and remove lid. Empty tank.
Pour dirty water out from the rear of the tank (Fig4/16).
The lid replaces in a hinge-like manner. Position the front
of lid under tabs on front of tank. Rotate lid down onto
tank.
NOTE:
Make sure that the lid is secure on all sides before
placing tank on cleaner.
NOTE:
For full suction, it is important that the recovery
tank lid is properly secured before cleaning (Fig.4/17).
Replace tank and press down to ensure that it is properly
seated in place. Rotate latches (one on each side of tank)
inward to lock tank in place. To continue cleaning stairs or
upholstery, replace hose as shown on pages 12 and 13.
Raise handle to upright position and replace upper clean
solution tank (Fig.4/18).
Fig.4/14
Fig.4/15
Fig.4/16
Fig.4/18
Fig.4/17
Rear of tank
Tabs
!
V-133 OasisComp User Guide v5.qxd:V-133 Oasis User Guide 8/9/08 14:44 Page 9