Vax Impact 502, Давайте начнем

Страница: 14 / 20

Let’s talk technical What to do if it goes wrong
Replacing the belt
Place belt on rounded
area of brush bar
without bristles.
Line up right side of
brush bar with base,
push into place. Lift and
push left side of brush
bar until clicks into place.
Lie vacuum cleaner
on its back exposing
brush bars. Use a cross
head screwdriver.
Undo 5 screws
Line up brush bar
cover, push until it
clicks into place.
Replace 5 screws
and tighten.
Lift to remove
brush bar cover.
Lift to remove brush
bar. Remove and
dispose of old belt.
Clean any debris from
spindle. Place new
belt on spindle.
Remove hose end
from the floor head.
Lift clip under the
hose inlet.
Pull latch out and
remove hose.
Line up latch, push until
it clicks into place.
Removing a blockage from the hose
If the brush bar does not rotate
easily then the belt may not
have been fitted correctly. Make
sure the belt is not twisted.
WARNING
TIP: Test for blockages by dropping a small ball of paper through the those. Remove any blockage by inserting wire
coat hanger into hose.