www.vax.co.uk
4
assembly / operation
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1.
Insert the flexible hose connector into the inlet on the
main body of the vacuum cleaner by lining up the
arrow on the connector (1) to the inlet recesses. Then
rotate the hose 90 degrees clockwise (2) to lock the
hose in to position (Fig.3/1).
2.
Push the telescopic extension tube on to the end of
the handle (Fig.3/2).
3.
The telescopic extension tube can be lengthened or
shortened by pushing the button in and sliding the
tube apart or together as required (Fig.3/3).
4.
Fit the combination floor head by pushing onto the
extension tube (Fig.3/4).
4. How to Operate
Cord Release
Fully unwind the power cord. A yellow mark on the power
cord indicates the recommended cord length. Do not
exceed the cord length beyond the red mark.
On/Off Button
Insert the power plug into the electrical outlet. Ensure the
vacuum cleaner is switched off.
Press the on/off button located on the top of the vacuum
cleaner and press the button again to turn the vacuum
cleaner off.
Carpet Cleaning
For carpet and rug cleaning press the rocker switch on the
combination floor head to raise the brushes.
Hard floor cleaning
For hard floor cleaning, press the rocker switch on the
combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord rewind button,
located on the top of the vacuum cleaner, and guide the
power cord with one hand. This will prevent the cord from
whipping which could cause damage or injury.
Carry Handle
Use the carry handle located behind the cord rewind
button and on/off button to move the vacuum cleaner
from room to room.
Hose Storage
For convenience there is a slot located at the rear of the
vacuum cleaner where the floor tool and hose can be
parked for carrying and storage.
Fig.3/1
1
2
Fig.3/2
Fig.3/3
Fig.3/4
!
Vax VEC-01&02 User Guide.qxd 27/9/07 17:17 Page 4
