background image

Taking care of your machine

Cleaning the separator, shroud and separator plate

Post-motor filter maintenance

Push the post-motor filter 

cover release clip to the right 

to remove the post motor 

filter cover.

Pull the post motor 

filter to the left and 

remove the post 

motor filter.

Check the post motor filter for discolouration. 

Do not wash the post motor filter.

Remove dirt container 

by pushing down the dirt 

container release button and 

lifting the dirt container.

Hold the dirt container over 

a bin. Push down the dirt 

release clip at the bottom 

of the dirt container. 

The dirt release door will 

open allowing dirt/debris 

to fall out.

Emptying and cleaning the dirt container

Taking care of your machine

IMPORTANT:

 Always switch off and unplug the vacuum cleaner from the electrical socket before assembling, 

opening or emptying the dirt container, or before connecting/disconnecting the attachments.
Pre-motor filter should be tapped over a bin every 4-6 uses to remove dirt and debris. Do not use your vacuum 

cleaner without all of the filters in place.
The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat will 

automatically turn the unit off.

!

40˚C

MAX 

24hr

TIP

Don’t over fill the 

dirt container to 

avoid blocking the 

air flow through the 

vacuum cleaner.

After emptying the dirt container, twist the separator 

clockwise to unlock and lift to remove.

Lift the dirt bin lid 

release clip. In a hinge 

like manner lift open 

the dirt bin lid.

Cleaning the Pre-motor filter

Pull the filter tab and 

remove the pre-motor filter.

Tap the filter over a bin

to remove any dirt/debris. 

Wash the filter under 

running water 

(40 degrees max).

Refit the pre-motor filter 

into the dirt container 

with the tab being visible.

Leave for 24 hours 

or until fully dry 

before replacing.

In a hinge like manner 

close the dirt bin lid until 

it clicks into place.

click!

CAUTION:

 Incorrect fitting of the separator cap will reduce suction.

24hr

IMPORTANT:

 The post motor filter is designed to offer long life with no maintenance. The filter should 

be checked periodically and when heavily discoloured it should be replaced. Please do not wash, 

scrub or brush the filter as this will damage the filter  

Содержание Dynamo Power Total Home VX54












Отзывы: