TIP
Brushes on the floor head
should be visible when using
on hard floors.
Assembling your upright
Press both buttons at end
of hose and insert into
hose entry point.
Unwind the power cord.
Do not pull further than the
yellow marker.
Insert hose grip into
extension tube.
Plug into mains and push
the on/off button to turn
your machine on.
Insert the other end of the
telescopic tube into the
floor head.
Before you begin cleaning
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner
off and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry
before putting back into the machine).
For best cleaning results clean the pre-motor filter every time the dirt container is emptied and replace
the post-motor filter every 12 months.
If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
Important: The base of the vacuum cleaner should always be positioned flat on the floor when starting and in use.
WARNING: When unwinding the power cord do not pull further than the yellow marker.
Getting started
Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
WARNING
Always switch off the vacuum
cleaner before connecting
or disconnecting the hose
/attachments, or removing and
emptying the dirt container.
For use on carpets, click
rocker switch forward. For
use on hard floors click rocker
switch back.
Slide vent cover on hose grip open
to reduce suction if required.
Lower brushes for hard floors.
Raise brushes for carpets.
