Using your machine
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum).
• Pre-motor filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the brushbar is switched to the off position.
NOTE:
When the vacuum cleaner is stood in the upright position the brushbar will automatically stop.
Telescopic extension tube
Remove hose end
from the floorhead.
Remove telescopic
extension tube.
Choose an accessory.
(Note: Some tools will
require the tool connector
when fitting).
Attach accessory
to hose end.
3-in-1 tool converts into:
A = Crevice Tool
B = Upholstery Tool
C = Dusting Brush
A
B
C
Attach accessory to
telescopic extension tube.
Attaching the hose
Attach hose to telescopic
extension tube.
Using accessories
NOTE:
The crevice tool, dusting brush and upholstery tool can all be attached to the telescopic tube or directly to the hose.
Accessories may vary.
