Assembling your vacuum cleaner
Line up hose connector with hose
entry point. Squeeze both buttons
on either side of hose connector.
Line up and push the other
end of the telescopic tube into
the powered head until
it clicks into place.
Push hose connector into hose
entry point until hose connector
clicks and locks into place.
Slide the adjuster on the
telescopic extension tube and
select required length.
Line up hose handle with
telescopic tube. Push hose handle
into telescopic tube until clicks and
locks into place.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Getting started
CAUTION:
Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
IMPORTANT:
The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off
and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour (if you have cleaned the filter please wait 24 hours for the filter to fully dry
before putting back into the machine).
If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
