www.vax.co.uk
8
clearing blockages / troubleshooting
Switch the vacuum cleaner off and disconnect the power
plug from the electrical outlet.
Lay the TurboBrush floor head on a flat surface and turn
over to expose the brushbar. Using a pair of scissors, cut
through any threads or hairs caught by the brushbar that
have wrapped around the guides (Fig.9/3).
10. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: Vacuum cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution:
Plug unit in firmly.
Cause:
Vacuum cleaner not turned on.
Solution:
Press on/off button.
Cause:
No electricity in the electrical outlet.
Solution:
Check fuse or breaker.
Cause:
Blown fuse / tripped breaker.
Solution:
Reset circuit breaker or replace fuse.
Cause:
Motor thermostat has tripped.
Solution:
Switch off and unplug the vacuum cleaner.
Leave for one (1) hour. See page 3.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Dust bag not installed correctly.
Solution:
Review dust bag removal and replacement.
Cause:
Dust bag full or blocked.
Solution:
Replace dust bag.
Cause:
Clogged filter.
Solution:
Remove filter and clean.
Cause:
Blockage in hose.
Solution:
Disconnect hose, remove the obstruction
then re-fit.
PROBLEM: Accessories won’t pick up.
Cause:
Accessories not attached correctly.
Solution:
Refer to page 7 for fitting information.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause:
Dust bag full.
Solution:
Dispose of dust bag, replace with a new one.
Cause:
Dust bag not installed correctly.
Solution:
Review dust bag removal and replacement.
Cause:
Hose not installed correctly.
Solution:
Review hose installation.
Cause:
Filter not installed completely.
Solution:
Review filter removal and replacement.
!
Fig.9/3
Vax 8131A Pet&Stair Guide.qxd 13/6/07 17:34 Page 8
