1
Assembly of the “bottom“
guide slide
The guide slide (ball-bearing)
is screwed to the floor board
17 mm from the cabinet front
edge and 10 mm (depending
on door strike left / right) from
the middle to the middle of the
1st drill hole of the guide slide.
Fasteners:
countersunk screws 4.0 x 16
Now place the sleeve spacers
(brass) on the threaded studs.
Then snap the plastic cover
over it.
2
Assembly of the “upper“
guide slide
The guide slide (ball-bearing)
is screwed to the ceiling board
17 mm from the cabinet front
edge and 10 mm (depending
on door strike left / right) from
the middle to the middle of the
1st drill hole of the guide slide.
Fasteners:
countersunk screws 4.0 x 16
Then snap the plastic cover
over it.
3
Assembly of the
driver “top / bottom“
The supports for the drivers
are to be placed in such a
manner (using 110 degree
hinges) that from the cabinet
edge hinge tothe middle of the
1st screw hole there are
84 mm.
The distance of the cabinet
edge door “top“ or “bottom“
amounts to 17 mm +
door strike.
Fasteners:
countersunk screws 4.0 x 16
17
32
182
32
144 (141)
16 (19)
10
84 mm
guide slide upper
threaded studs
plastic cover
sleeve spacers (brass)
countersunk screws 4.0 x 16
cabinet front edge
cabinet width 300
hinge left
guide slide lower
plastic cover
countersunk screws 4.0 x 16
countersunk screws
4.0 x 16
countersunk screws
4.0 x 16
driver
driver
Halter
support
door
17 mm +
door strike
door top
door bottom
support
