Vauni OF Wide, Руководство пользователя

Страница: 12 / 40

12 |
Vauni Globe © Copyright 2015 Vauni AB - All rights reserved
ENG
4.2.2 Refilling with fuel
Warning! Denatured ethanol burns with an almost invisible flame under certain conditions.
This may happen, for example, when the level in the burner is low. Therefore it is very important
that the burner is extinguished completely after use, and that it is allowed to cool for at least 15
minutes before more fuel is added. To add fuel in a burning burner is very dangerous and can
cause an explosion.
Note 1! Add fuel when the burner is about to be used – the burner has a safety function that
makes it harder to start when the fuel has been standing for more than 20 minutes. Read more at
point 4 in Section 4.1 Lighting the burner.
Note 2! The burner may contain fuel from previous firing. The tank’s total volume is 2 (3 CI Wide)
litres. Therefore, do not add more than is needed according to point 5 below.
The following steps should be taken when adding fuel:
1. See that the burner is completely extinguished, by checking that the regulator lid is closed,
and that the burner has been allowed to cool for at least 15 minutes with the lid closed.
2. Check that the correct fuel is used. Vauni recommends that the burner be filled from bio-
ethanol packaged in bottles of 1 litre.
3. Open the regulator lid completely. Start filling by holding the bottle to the burner’s opening,
angled so that the fuel flows in the burner’s length direction, from right to left or vice versa.
(Figure 10) Pour the fuel carefully down into the burner matrix. If necessary, a stainless steel
funnel can be used as an aid. Add carefully until fuel is no longer absorbed by the burner
matrix. The liquid level must not rise above the burner matrix by more than 1 mm. (Figure 11)
Then the burner is fully tanked, which corresponds to 2 (3 CI Wide) litres of bioalcohol.
Note! For safety reasons the fuel transfer occurs with some delay. To avoid over-filling the
burner, it is important to give the fuel time to settle downward. Be especially careful, therefore,
during the last part of the filling. Let the bottle drip a little over the opening before removing it.
4. Be careful to avoid all spillage – any spill should be wiped off with a piece of paper. If over-
filling occurs, use suitable utensils to remove excess fuel, so that the fuel comes level with the
burner matrix.
4.2.3 Handling of spillage
Avoid all spillage as far as possible. Take good time when refilling. If an accident does occur,
observe the following.
10 11
m a x