Vauni Divider, Руководство пользователя

Страница: 7 / 36

© Copyright 2015 Vauni AB - All rights reserved Vauni Divider
| 7
ENG
6. The Divider is equipped with transparent covers to protect the glass from irregularites on eg
hard floors. Its important not to remove these covers, as to do so may lead to cracks.
(Figure 5)
7. Check that the hearth stands steadily.
Now that the hearth is completely assembled, read Section 4 Firing for instructions on how to
start it the first time
4 FIRING
Be careful to read through this section and make sure that all users of the hearth understand the
safety prescriptions before it is put into use.
4.1 Lighting the hearth
At the first start, points 1-6 are followed. For later normal use, points 2-6 are followed. When
repositioning, or making other changes in the hearth’s surroundings, points 1-6 are to be
followed.
Note! Do not add fuel if you do not intend to start the hearth immediately; see Section 4.2.2
Refilling with fuel below.
1. See that the assembly and installation are done according to the instructions in Section 3.
2. Check that the regulator lid lies closely against the burner’s surface and slides easily when the
regulator rod moves it to its respective stop. When the lid is in the closed position, it should
cover the entire burner opening.
3. Open the regulator lid completely with the regulator rod. Add fuel according to the instruction
4.2.2 Refilling with fuel below. If the hearth is recently used, allow it to cool down for at least 15
minutes.
Warning! Fuel must never be added in a burning hearth!
4. Check that there is no spilled fuel on or outside the hearth. Light the hearth by holding a
lighter with extended tip next to the burner matrix. See that no inflammable material is
present within a distance of 1 metre. The hearth will start immediately, and in a short time
5 4
1 meter
© Copyright 2007 Vauni AB
6
min 1 meter