Vaughn Hydrastone ME Series, Руководство по эксплуатации и установке

Страница: 4 / 20

3
I NSTALLATION GUIDELINES
A. INSPECTING AND PREPARING THE HEATER

Do not cover or damage the temperature and pressure relief valve
opening located in the topside of the tank (see Figure I).
B. LOCATION

CAUTION: All tanks will eventually leak at some unpredictable time.

Do not place the heater where there is a risk of property damage in the event
of a leak.

Place the heater on a solid foundation in a clean, dry location.

The heater should be protected from freezing and water lines should be
insulated to reduce energy and water waste.

Leave sufficient room to service the heat exchanger and electrical controls.

Do not install in an area where flammable liquids or combustible vapors are
present.

CAUTION: The heater’s outer jacket is plastic and can melt.

Do not install in close proximity to wood burning stove or other high
temperature apparatus.
NOTE: If Heater is Placed On Blocks To Raise It From The Floor,
Be Sure to Support The Entire Bottom With At Least ¾" Plywood
On The Top Of The Blocks.