Vatech A9 (PHT-30CSS)
Technical manual
VDH-TeM-098
10 / 214
COPYRIGHT© 2020 VATECH
.
ALL RIGHTS RESERVED
Equipment Safety Instructions
This electro-medical device contains high voltage and current flowed parts, and the following
instructions must be followed to avoid critical damage to the body and equipment.
Electrical Safety Caution
•
The equipment and PC should be connected to a common
protective earth. Confirm that the equipment is well-grounded.
•
High voltage and current flows throw equipment. Turn off
equipment power and wait at least 2 minutes before the operation
begins.
•
Do not connect this equipment to any device without authorization
from VATECH Co., Ltd.
•
Do not connect this equipment to a Multiple Portable Socket- Outlet
(MPSO) or extension wires
•
Keep in mind that MCU boards are electrically sensitive that
operators need to wear shielding gloves while operating.
•
The only part that can be replaced by the users is the input fuses.
Check if the fuses comply with the manufacturer’s specifications.
Mechanical Safety Caution
•
Be aware that fingers or parts of your body are not shut in the
equipment.
•
If a problem occurs during operation, immediately press the red
emergency stop button to stop equipment operation and cut off all
power to the equipment.
•
Never touch the patient while touching the connector of SIP/SOP.
•
While adjusting the patient, ensure that the laser beam is not
directed at the patient’s eyes.
•
Never expose the equipment to liquids, mists, or sprays. Any liquid
may cause an electrical shock or otherwise damage the system.
•
Do not use spray cleaners on the equipment to avoid fire.
•
Do not use solvent aerosol or spray cleaning agents directly on the
surface of the equipment. It can damage equipment, including the
LCD panel.
