Using the Grid for Aligning Artwork
2a
2b
1) Install a glue dot, double sided tape or
single sided tape under the positive
with 1/2” sticking out.
2) Take a coated and dried screen and
carefully position it against all three
stops without contacting the tape and
positive.
3) While holding the screen against all
three stops, carefully slide the screen
down onto the positive.
4) Press the screen firmly over each tape
to secure.
5) Release the carrier sheet from the pins
and carefully lift screen, positive, and
carrier sheet. Do not allow the carrier
sheet to pull away from the screen.
6) Repeat steps 1-5 for each screen.
Center the Screen Over Artwork Grid
Place a screen against both bottom stops and
center the screen left to right over the art work
grid. To adjust the side stop, use a 9/16” wrench,
loosen the mounting bolt slightly and slide in or
out, retighten.
Expose the Screen
3
1) Take each screen with positive and
carrier sheet to your exposing unit and ex-
pose for the proper amount of time. Care
should be taken to ensure the carrier sheet
is firmly attached to the screen.
Fig 3
Positioning Screens Into Printheads
(Graphics are for reference only and do not reflect actual Fixture Pallet Jig / Pin Board Combination)
1) Level heads, set off contact to 1/8” and
center all micro adjustments.
2) Position the Fixture onto a pallet. Pull back
firmly and tighten both side clamps.
3) Adjust your shirt pallet in or out to ensure
proper screen depth into the screen clamp.
The screen must be able to contact both
back screen stops without contacting the
back of your screen clamp, see below.
Fig 4
Fig 2
4a
Fixture
Screen
Stops
Screen
Fixture
Must Have Gap
Glue Dot or
Double Sided Tape
Pallet
Clamps
Pg3
