VASTEX DiGiT V2NS-8, Сборка и руководство по эксплуатации

Страница: 3 / 8

Site Rail Installation
1) Loosen the three phillips head screws circled in the picture below.
2) Slide the Site Rail under the screw heads and tighten.
Be sure to install the correct Site and Detent Rails to match the
screen you will be using.
Detent Rail Installation
Site Rail
Note
The Site and Detent Rails can be in-
stalled while the numbering attachment
is on the press. This is shown off the
press for instructional purposes only.
(The picture above shows the correct
orientation of an installed Detent Rail.)
Detent Rail
3) Site Rails should be labeled from the factory as shown below.
3
31 13
L R
1
11
11
5
15 51
4
41 14
2
21 12
L R L R L R
L R
8
81
18
L R
6
61
16
0
10 01
9
91 19
7
71
17
L R L R L R L R
1-5
6-0
Target
The Site Rail is a visual aid for selecting the desired print location of the numbers.
The Detent Rail controls the location of the number. Five positions are available for each number. This is a very important step.
The grooves in the Detent Rail
engage into a Roller Bearing,
locking the screen into position.
1) Loosen the three philips head screws on the Detent Rail. (shown below)
( V2NS-12 has 5 screws to install Detent Rail.
2) Slide the Detent Rail onto the bottom of the Numbering Attachment and
tighten them down well. See photo (bottom right) for visual reference.
Be sure to install the correct Site and Detent Rails to match the
screen you will be using.
Roller Bearing
Important!
Detent rails must be installed as shown
below. Be sure grooves in rail lock into
the roller bearing!